JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Home
Frequently Asked Questions
Can the Pocket Hole Jig be used for mitred frame corner joints on material less than 50mm wide?

Frequently Asked Questions

Can the Pocket Hole Jig be used for mitred frame corner joints on material less than 50mm wide?

Yes, the jig can be used to create pockets for mitred frame corner joints. It may be necessary to tilt the pocket hole piece so that the hole is not perpendicular to the mitred edge, so as to prevent the pocket from breaking out of the top edge.

Created by Trend Support Team

Was this article helpful ?