Frequently Asked Questions
Tag : Routing
The shank length is 63mm, the overall length is 115mm.
No, the 1/4 collet is actually 6.35mm, a difference of .35mm which is critical in terms of collet and shank sizes.
The part numbers are: CE/127127 & CE/127635.
The overall length of a 5/53X1/2TC is 103mm.
The dimensions of the router plate is 306mm x 229mm x 6.35mm.
The cutter required is 3/83X1/2TC, 3/83DX1/2TC, 3/85X1/2TC, RT/11X1/2TC.
A sleeve will fit on to the shank of the cutter to increase the shank size, where as a collet will fit into the router to enable different shank sizes to be inserted in to the router.
Total cutting height is 35mm.
A B63B will fit both cutters.
B35C is the bearing required.
It is a cutter for cutting circular hinges. Trend offer the 104, 105 & 421 groups for this purpose.
To convert the PDS set into a tongue and groove cutter set the following are required SP-34/74TC, SPACER/8
You can not re-sharpen the 10/99 because the dimensions for the tongue and groove will change making them incompatible, however, the pocket whetstones if used will help to keep a keen edge on the carbide.
A rule joint can be cut with either the OCTACUT sets or something like the 7/5X1/4TC and 6/5X1/4TC cutters.
We now offer a 60 degrees V-groove with a 1/4 shank (ref 11/20X1/4TC) and also a larger diameter 45 degrees V-groove which has a 19.1mm diameter by 1/2 shank (ref 11/41X1/2TC).
The T10/T11 trammel bar and attachment can be used on any router that uses a 10mm diameter fence rod.
The cutter required is trend ref 36/19X1/4TC.
The cutter that will give a fine finish on both veneers is either the 14/1x1/2TC or 14/2x1/2TC, up and down shears.
The holes are 6mm and 24mm between centre.
The T5 beam trammel or attachment can be used on any router that uses an 8mm diameter fence rod.
The UNIBASE is required.
The templates can be clamped or stuck with double sided tape.
The UNIBASE is required.
The thickness of the Trend Unibase is 8mm.
In the UK and America, jigs work in imperial sizes the cutter set required is SET/MT1X1/4TC, SET/MT1X8MMTC. For jigs set up in millimetres the cutter set required is SET/MT2X8MMTC.
The overall length of a 3/83X1/2TC is 108mm
The overall length is 109mm.
34/15TC.
The overall length of a 3/82X1/2TC is 79mm.
The shank length is 57mm the overall length is 108mm.
The overall length is 99mm.
Slotseal Carripile is not available from Trend. Carriplie II was made originally made by Slotseal. Reddiseals offer a similar centre leg pile carrier.
The overall length of a 3/83MX1/2TC is 84mm.
Schlegel Engineering, Henlow Ind Estate, Henlow Camp, Bedfordshire, SG16 6DS Tel no. 01462 811963.
